![]() Since my height, width, and radius is different from the one in those plans, I needed to buy more materials and double up the 2x4s in a few different locations where plywood seams would meet. I followed the basic guidelines from with some adjustments here and there. However you decide to design your mini ramp, you’ll want to make sure that you’ve got 2x4s under each seam of plywood and surface layer. This could mean adding an additional 2×4, needing an extra sheet or two of plywood, or finding a specific solution for whatever situation that comes up during the build. If you use existing plans, but choose to alter your dimensions (different height, width, transition radius, etc.), just note that you’ll need to make some adjustments as you assemble. As with anything found online, you’ll likely find that there are some different ways you’d prefer to do things. There are plenty of designs and mini ramp plans online to help you get started. 1/8″ masonite skating surface layered on 45 degree diagonals.2″ steel pipe coping (actual OD 2 3/8″).Just over 3.5′ high from ground to deck.The mini ramp shown here has the following dimensions & features: But other than that, the only thing standing between you and your new mini ramp is time.Īnd it is possible to do this by yourself, the mini ramp featured in this article was assembled entirely by 1 person. Now, it does help to have a helping hand and some experience working with tools, taking measurements, and making cuts. Draw your transition radius and cut your plywood sides.The basic process for building a mini ramp is as follows: I was initially going to go 16′ wide, but adjusted midway through (more on that below). ![]() Luckily, since the material you’ll be using is typically sold in 8′ lengths, you do have some flexibility to adjust your plan slightly after your get started. If you go the DIY route, there are plenty of mini ramp plans and Youtube videos to get you through the process (I’ll include some of the most helpful ones below).Īside from the repetitive nature of the cutting, drilling, screwing, and assembly, the hardest part about building your own mini ramp is deciding on the dimensions. I’d build a backyard mini ramp in my workshop.īuilding a mini ramp, AKA a small half pipe, is not too complicated.Īnd, you’ve got options as to whether or not to build vs. The good news was that it did in fact quench my urge to surf.īut, flat ground skating could only take be so far. It hurts a lot more than what I remember growing up. I bought a new skateboard and worked on getting my skate legs back. Skating would also be a great cross-trainer for surfing too. ![]() Skateboarding was born from surfing, so it made sense that I could use it to satisfy my surfy cravings. ![]() I couldn’t just get a quick fix whenever I had the urge. The surf cams and reports were more of a novelty rather than a necessity.īut, once I moved I had to give a little more thought to my sessions. When I could bike to the beach, going down for a quick surf even if the waves were bad was no big deal. Still very lucky, no doubt, but the change did require me to adjust my surfing habits. Over the summer I moved from a 10-minute e-bike ride to a 25-minute drive to go surfing. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |